| Data still to be completed------(Home) | |
|---|---|
| PRODUCT DATA of Cycom C69 |
| Material | Cycom C69 |
| Product Type | Prepreg for laminates. |
| CAS Registry Number | Modified epoxy/High modulus carbon fibres. |
| Name of Manufacturer | Cytec Fiberite Ltd
Abenbury Way, Wrexham Ind. Est., Wrexham LL13 9UZ, Clwyd, UK +44 (0)1978 665 200 +44 (0)1978 665 222 www.cytec.com |
| EXPERIENCE IN PRACTICE |
|---|
| Development Status | Commercial Product |
| Cost Range | High |
| Lot Reproducibility | Very Good |
| Space Experience | Fair |
| PHYSICAL PROPERTIES |
|---|
| Specific Gravity | 1.63 |
| THERMAL PROPERTIES |
|---|
| Thermal Expansion Coefficient | -0.7 μstrain/°C Remark: Long.; Trans. 30 x 10-6 /°C) Manufacturer’s Data |
| RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY |
|---|
| Temperature Range(space) | -130°C to 180°C. Test:Manufacturer’s Data |
| Outgassing(Avg data) | TML = 0.6%, RML =0.3%, CVCM = 0.01% Test:ECSS-Q-70-02 |
| Humid Heat | 750 hours – no sizeable effect Test:70°C – 95% |
| SPECIAL RECOMMENDATIONS |
|---|
| Special Recommendations | Recommended cure is one step at 140°C, pressure application (0.7 MPa), then 1 hour at 170°C. Post cure: 3 hours at 180°C. · The same resin can accommodate High Strength (HT-S) or type AS carbon fibres. · When continuous use temperature does not exceed 120°C, another prepreg with similar properties, Carboform 87, can be used. |