| All data is for information only------(Home) | |
|---|---|
| PRODUCT DATA of Inconel 600 |
| Material | Inconel 600 |
| Product Datasheet | Inconel alloy 600 |
| General Information | Inconel 600 is a corrosion- and heat-resistant nickel-base alloy used for low-stressed parts operating up to 1150C. It is not hardenable except by cold working and is usually used in the annealed condition. Inconel 600 is available in all the usual mill forms. |
| Chemical Composition | 6-10Fe, 14.7-17Cr, 0.15C, rem Ni |
| Name of Manufacturer | Special Metals Wiggin Ltd
Hereford, England +44 (0)1432 382200 +44 (0)1432 264030 info@specialmetalswiggin.co.uk |
| EXPERIENCE IN PRACTICE |
|---|
| Development Status | Commercial Product |
| Equivalent Designations | ASTM B-166, LN 2.4640, 2.4816, NiCr15Fe |
| Space Experience | Good |
| PHYSICAL PROPERTIES |
|---|
| Specific Gravity | 8.42 |
| Magnetic Properties | Nonmagnetic |
| Curie Temperature | -124 °C |
| Relative Permeability | 1.01 |
| ELASTIC PROPERTIES |
|---|
| Tensile Modulus | 214 GPa |
| Shear Modulus | 80.8 GPa |
| Poisson Ratio | 0.324 |
| ELECTRICAL PROPERTIES |
|---|
| Electrical Volume Resistivity | 0.00000103 ohm.m |
| THERMAL PROPERTIES |
|---|
| Thermal Conductivity | 14.9 W/m.K Data Quality: Manufacturer's data |
| Thermal Expansion Coefficient | 13.3 μstrain/°C Data Quality: Manufacturer's data |
| Specific Heat | 0.461 J/g.K |
| Melting Range | 1370 to 1430 °C |
| RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY |
|---|
| General Corrosion Status | No specific corrosion protection required |
| Corrosion/Thermal | The alloy does not embrittle after long exposure at high temperatures. Contact with sulfur-containing atmospheres at elevated temperatures should be avoided |
| Atmospheric Corrosion | The alloy will remain bright indefinitely in indoor atmospheres |
| Stress Corrosion Status | High Resistance to SCC: Table 1 Remark:In annealed state, including weldments Data Quality: Design Data |
| Bimetallic Corrosion | Can be connected without any restriction to: 400 series Stainless steel
Can be connected in a non-controlled environment to the above and 300 series stainless steel, Ti and Ti-alloys, Cr, Cu, brasses, Cu-Ni, Al-bronzes, Si-bronzes, Can be connected in a clean room environment to above and Ag, SnPb alloys, Sn, Pb, low C steel, Al-Cu alloys, Cd, Au Needs specific measures: All others Test:ECSS-Q-ST-70C Rev.1 Table 5.1 Data Quality: Design Data |